Pixie
27
Pixie4D (first generation)
JP2 is used to connect inputs (interactive
show triggers) to the controller.
JP3/JP4 jumpers select the network wiring on
the RJ45 jacks (LOR or DMX). DMX network
shown. It is recommended that you leave the
top-most jumper off in LOR network mode.
This will disable accessory power to the
network jacks.
JP5 is used to select some factory
configurations and must be empty to allow
Hardware Utility setting of RGB IC,
pixels/string, and color order.
The fuse limits current for all four strings.
Pixie
28
Pixie4D (second generation)
POW
E
R INPUT
S
FUSES
RESET/TEST
STATUS LED
JP2 install jumper to connect accessory
power to RJ45 jacks.
JP3 is used to connect inputs (interactive
show triggers) to the controller.
JP4 install jumper to connect 120Ω
termination resistor.
JP5 is used to select some factory
configurations and must be empty to allow
proper operation of the Pixie4DMX and to
allow the Hardware Utility setting of
pixels/string and color order.
The fuses limit current for individual strings.
