Installation Instructions Crouse-Hinds Champ® VMV
LED-8929***-HAZ & LED-8929***C-HAZ
Instructions for retrofitting the following UL
Listed Crouse-Hinds Champ® VMV Series HID
Luminaire Fitting/Ballast Housing marked for
Use in Class I, Division 2, Groups A, B, C and D
Hazardous Locations
Fitting
Champ® Catalog #
Ballast Housing
VMVS & VMVM
Champ Cover
(Mounting Module)
APM2, APM3, HPM2,
CM2, CM3, TWM2,
TWM3, JM5, PM5,
QM25
Optical & Guard
components
G24, G24 S808, P21,
RD70, RA70, G241,
G243, G245, P241,
R2, R3, R5, P23, PR2,
PR3, PR5
Tools needed:
1. Slotted screwdriver
Note:
The luminaire does not need to be removed
from the mounting surface prior to
modification.
Retrofit Kit Selection Table
Ballast Housing
Retrofit Kit
VMVS050, VMVM070,
VMVM100
LED-8929E**-HAZ
LED-8929E**C-HAZ
All Others
LED-8929M**-HAZ
LED-8929M**C-HAZ
Champ® is a register trademark of
Eaton’s Crouse
-Hinds
4
1. Disconnect electrical power to the luminaire at
the supply source
CAUTION
–
Risk of burn, allow luminaire
and lamp to cool before proceeding
3. Allow the ballast cover to hinge open.
4. Remove the wire connectors from the
incoming wires to the ballast circuitry. Be
careful to leave the green ground wire
connected.
2. Open luminaire by loosening the screw that
holds the ballast housing and cover together
INCOMING
WIRES
WIRE
CONNECTORS
