8
☐ Repeat the previous five (5) steps and assemble a second element that is of the same orientation as the first
Element assembled.
☐ The remaining two (2) Elements are assembled
in a similar fashion as the previously assembled
Elements except the orientation is opposite. See
the following figures. See (Fig. 24 through Fig. 27)
Note: The slit-end of the tubes are positioned on the
left side end of each tube. Also note that the hose clamp
screws are above the tubes. Note the orientation of both
hose clamps.
☐ Assemble the remaining two Elements as shown in
Fig. 24 through Fig. 27.
Complete the following steps for each of the four (4) 0.5” x 24” fiberglass rods.
☐ Select a 10-24 x 1.0” SS Machine Screw, a 1/8” No. 10 Black Cable Clamp, and a 10-24
SS Anti-vibration Hex Nut. Insert the hardware through the hole of the fiberglass rod
as shown in Fig. 28.
☐ Insert each completed rod sub-assembly into each element sub-assembly as shown
in Fig. 29.
The four (4) Element Sub-Assemblies are now complete as shown in Fig. 30.
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Fig. 29
Fig. 30
