21
☐ Select one (1) of the two (2) Wire Assemblies
that is labeled
20D
. This is a 20 M Driven
Element. Carefully unwrap the wire bundle.
Note that the wire is folded back upon itself
at one end. This is the outside end of the
element. Connect the ring terminal on the
other end of the wire and position it at the
terminal plate as shown in Fig. 82. Remove
the 10-24 SS Anti-vibration Hex Nut, place
the ring terminal over the machine screw and
replace the Hex Nut. Tighten well.
☐
At the Driven End of the antenna
, temporarily
remove the two (2) 10-24 SS Anti-vibration
Hex Nuts and Black Cable Clamps,
then insert the wire through both.
Replace the Black Cable Clamps
with wire and the Hex Nuts on the
Machine Screws as shown in Fig. 83
and tighten well.
☐ Twist the driven and reflector
element wires to remove curl from
each wire.
☐ Pass the black cord that is attached
to the ring terminal of the 20M
Driven Element Wire through the
ring terminal of the 20M Reflector
Element wire as shown in Fig.
84. Pull the cord through the ring
terminal till the wire tie is against
the ring terminal, then secure this
position with a knot.
☐ Select one (1) of the 1/8” x 2” Heli-
tubes and wrap the spiral tube
about the cord as shown in Fig. 85.
☐ Completely wrap the cord with the
spiral tube as shown in Fig. 86.
Fig. 82
Fig. 83
Fig. 84
Fig. 85
Fig. 86
