20
☐ Select the Wire Assembly
that is labeled
20R
. This is
the 20 M Reflector Element.
Carefully unwrap the wire
bundle. Note that the wire
is folded back upon itself at
both ends. These are the
outside ends of the element.
Where the wire is folded back
upon itself, this is the point
on the wire where the Black
Cable Clamp is located.
At the
Reflector End of the antenna
,
temporarily remove the two
(2) 10-24 SS Anti-vibration Hex
Nuts and Black Cable Clamps,
then insert the wire in both
as shown in Fig. 79. Replace the Black Cable Clamps with wire and the Hex Nuts on the Machine Screws and
tighten well. Position the Black Cable Clamps as shown in Fig. 79.
☐ At the other end of the wire from the
previous step, repeat the previous
step to fasten the wire within the
Black Cable Clamps located on
the other side of the Boom at the
Reflector End of the antenna as
shown in Fig. 80.
☐ On the Reflector Element end of the
Boom, locate the Black Cable Clamp
as shown in Fig. 81. Temporarily
remove the 10-24 SS Anti-vibration
Hex Nut and Black Cable Clamp,
then insert the wire. Replace the
Black Cable Clamp with wire and the
Hex Nut on the Machine Screw and
tighten well.
This completes the installation of the 20M Reflector Element.
Fig. 79
Fig. 80
Cable Clamps
Cable Clamps
Fig. 81
