14
(Fig. 20)
(Fig. 21)
(Fig. 22)
O-ring Care & Maintenance
O-rings are the critical component that keeps water out of the housing. Routinely inspect
O-rings and replace at least once a year. If your O-rings are damaged, contact your Light
& Motion dealer for an O-ring replacement kit.
Follow these steps for proper O-ring function:
1. The sealing system used on the monitor back and and the lens on the Stingray G2+
incorporates two O-rings. This is the most critical area of the housing for maintenance
and should be inspected before every dive.
2. Make sure the monitor back O-rings and the mating surface on the inside of the
main housing are free of grit, hair, lint and anything that could breach the O-ring
seal.
3. After frequent diving or if O-rings appear dirty, remove O-rings and clean the
grooves. To remove O-rings, use finger pressure or the rounded edge of a plastic
card to lift the O-ring out of the groove.
NOTE:
Never use a metal object to remove an O-ring. It will cause damage
to the O-ring and mating surface.