Light & Motion Bluefin SR11, Руководство пользователя

Страница: 18 / 28

(Fig. 27) (Fig. 28)
Installing Batteries
1. Slide the battery back into the pod with the contact end inserted first so that the
connector will align with the socket inside the pod (Refer Fig. 26).
2. Inspect the O-ring on the pod cap. (See O-ring maintenance).
3. Replace the front cap onto the pod.
Note:
Insure that the removal strap attached to the battery does
not interfere with the seal when the end cap is attached to the pod.
4. Turn the knob on the end cap clockwise 1/8 turn until it stops. The end cap will now
be locked into place. The end caps are specific to the left and right pods.
Removing Batteries
1. Rotate latch at the front of the pod counter-clockwise 1/8 turn, until it stops.
2. Pull the front cap off the pod.
3. Pull the battery from the pod using removal strap.
Mounting Battery Pods
1. Remove the monitor back of the housing.
2. Slide the battery pods into housing channels.
3. Position battery pods so that the IR transmitter from the monitor back aligns with the
IR receivers on the pods. (fig. 27)
4. Insert the Pod Locker between the pods and tighten using 1/8” Allen key.
Do not over-tighten. (fig. 28)
16