USER MANUAL
–
HDN
–
EN VERSION 02.01
Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
17
To reset a remote control so that it is no longer paired with a particular lift, do as follows:
Resetting the transmitter
1.
Press the UP (
↑
) and DOWN (
↓
) buttons at the same time and hold them down for approx.
5 seconds until the control LED on the remote control begins to flash slowly.
2.
The remote control is now in installation mode for 2 minutes. Perform the following
sequence within the 2 minutes:
Press: UP(
↑
), UP(
↑
), DOWN(
↓
), DOWN(
↓
), UP(
↑
), DOWN(
↓
), UP(
↑
), DOWN(
↓
)
If successful, the LED will flash rapidly 10 times.
Alternatively:
Press the Reset (S5), if the remote is open.
Test the system, to ensure the reset has been performed correctly and the remote control is
no longer paired; if not, repeat steps 1-3 above.
Resetting the receiver
1.
Press
‘
C
onnect’ (1)
on the receiver for
more than 10 seconds.
2.
When the control LED begins to flash
rapidly 10 times, the receiver has been
reset.
