USER MANUAL
–
EASYLIFT V3 PLUS
–
GB VERSION 2.1
Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
15
7.
Functionality
The EasyLift lifting platform is a so-
called “dead man operated” lift, i.
e. the push-buttons must
be pressed and held down for the entire motion.
The lift operation is straightforward; the user activates it, using one of the push-buttons on the
wall or by means of the remote control (optional equipment).
When the user is on the lift, it is operated from the side panel, from which the user can choose
to be transported to the upper or lower level respectively.
8.
Assembly
The lift installation is undertaken by an authorized service technician*.
Do not attempt to move, disassemble or repair your lift. These actions MUST be performed by
an authorized service technician*. Improper assembly may increase the risk of user injury. Liftup
is exempt from any liability if assembly and installation are not performed by an authorized
service technician*.
For more information or materials on assembly, you may contact your dealer (cf.
https://www.liftup.dk/en/distributors/#).
*Has completed a Liftup product and service course.
9.
Start-up
The lift must always be connected to a 110-240V power point and be powered on. Under normal
circumstances the lift is always in stand-by mode, i.e. it is ready for use as soon as one of the
operating buttons is pressed.
If the emergency stop has been pushed, it must be deactivated before the lift can be used (see
section 10).
