USER MANUAL
–
EASYLIFT V3 PLUS
–
GB VERSION 2.1
Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
25
Resetting the receiver of the lift
•
Switch the power to the lift on.
•
Short-circuit JP1-1 on the connection box board.
•
When the control LED begins to flash rapidly, the
receiver has been reset.
Should the control LED not flash rapidly, this means
that no receiver has been paired.
13.2
Wireless call station and receiver of the lift
The wireless call station and receiver must always be paired in order to work. The receiver will
not react to a wireless call station which is not paired with it. A receiver can be paired with up
to 20 wireless call stations. A wireless call station can be paired with several receivers if required.
When a receiver is powered on (see section 10.6) the RF-Status in the connection box will flash
for 2 minutes. Or until it is paired with a wireless call station.
Pairing wireless call station and receiver of the lift
1.
Make sure that there is power to the system. Press the
emergency stop and switch off the on/off switch on the
side of the lift (see section 10.6).
2.
Wall-mounted remote-controlled call station: Set dip
switch S4 #2 to ON and press on the contact or short-
circuit (
↑
) or (
↓
) using a metal object. The control LED
on the call station will start to flash slowly. The call station
is now in installation mode for 2 minutes.
Return S4 #2 to its starting position (off).
3.
Within these 2 minutes, release the red emergency stop
on the lift by turning it clockwise.
4.
The control LED on the call station is paired with the lift
when it stops flashing.
5.
Test the system so as to ensure the pairing has been
performed correctly. If not, repeat 1-5 above.
If you need to pair several call stations to the receiver,
repeat items 2-5 above.
6.
Switch on the on/off switch on the side of the lift.
Resetting wireless call station and receiver of the lift
•
Set dip switch S4 #1 to ON and press on the contact or connect (
↑
) or (
↓
) using a metal
object. The control LED on the call station will flash rapidly.
•
The pairing with the receiver has now been erased.
•
Return dip switch S4 #1 to off.
