30
31
Push a Carriage Bolt (CU) through the hole in
the top of the hinge and loosely place a 1/4”
Cap Nut (CC) on the bolt. Put the Left Door
Hinge (AU) into position. Repeat for the Right
Door Hinge (AT).
19b
19c
While one person holds the Door Header Channel (AK) in place, remove the Cap Nut (CC)
and slide the Door Header Channel (AK) over the bolt. Replace and tighten the Cap Nut (CC).
Remove the Cap Nut (CC) and slide the Door Header Channel (AK) over the Carriage Bolt (CU).
Replace and tighten the Cap Nut (CC). Screw the Door Header Channel to the Gable.
AU
AT
CC
CU
Screw the Door Frame Floor Brackets (at the
bottom of each hinge) to the fl oor. Insert the
remaining screws into the Door Hinges.
19d
FE
FE
CC
CU
CU
CC
CU
CC
CO
CO
Hardware Bags: 1011134, 1009126
Screwdriver
CC
(2)
FE
(4)
Step 19 Hardware (continued)
CU
(2)
AK
AK
19e
Install a Gable Truss Brace (BD) between the front truss and the Gable. Screw the Gable Truss
Brace (BD) into the Door Header Channel.
BD
Hardware Bags: 1011134, 1009126
Screwdriver
Step 19 Hardware (continued)
CN
CA
CB
CB
(1)
CA
(1)
Left Door Hinge
Right Door Hinge
Identify Left and Right Door Hinges
Each hinge has two components. A wider Wall channel that fi ts over the
wall, and a thinner Door Channel that holds the Door. When installed
correctly the “Door Channel” hinge will be above the “Wall Channel”
hinge.
Assembly T
ip #7
CN
(2)
WARNING
Do not overtighten the Cap Nut. If the
end of the Bolt breaks through the
plastic cap, call our Customer Service
Department at the number on Page One.
Exposed threads on the end of the Bolt
may cause serious injuries.
WARNING
Do not overtighten the Cap Nut. If the end of
the Bolt breaks through the plastic cap, call our
Customer Service Department at the number
on Page One. Exposed threads on the end of
the Bolt may cause serious injuries.
FE
(14)
FE
FE
There are no pilot holes in
the Gable to receive the
screws (CN). Insert them
directly into the plastic.
