4
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench and Phillips screw-
driver .
Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below
each drawing refers to the key number of the part, from the PART LIST on page 10. The second number refers
to the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is not in
the parts bag, check to see if it has been pre-attached.
M10 Zinc
Washer (62)–2
M10 x 85mm Carriage Bolt (48)–2
M10 Black Nylon Locknut (50)–2
M10 Zinc Nylon Locknut (61)–2
M8 Split
Washer (56)–3
M10 Black Split
Washer (45)–2
M8 x 45mm Button Screw (54)–1
M8 x 37mm Button
Screw (55)–2
M6 x 16mm Button
Screw (57)–8
M10 x 56mm Carriage Bolt (49)–2
M6 Nylon
Locknut (53)–4
M6 x 34mm Button
Screw (52)–4
M10 x 75mm Button Bolt (51)–2
1. Identify the Front Stabilizer (2). Turn the Front
Stabilizer so that the warning decal is in the position
shown. While another person lifts the front of the
Frame (1) slightly, attach the Front Stabilizer to the
Frame with two M10 x 85mm Carriage Bolts (48) and
two M10 Black Nylon Locknuts (50).
2
50
48
Decal
1
1
