LifeSpan TR2000-HRC, Руководство пользователя

Страница: 13 / 28

9
Step 4: Console Assembly (Fig 4)
1. Remove the 6 screws (19) from the
back of the console and hold until the
wiring harnesses are all connected.
2. Hold the console close to the console
bracket. It’s helpful to have someone
hold the console in place while a 2nd
person connects the wire harnesses.
3. Connect cables (21A) and (21B). This
is the main wire harness with a 5 pin
and 7 pin connector.
4. Connect the handlebar pulse cables.
There is one harness with a 2 pin
connector coming from right and left
side handlebars. These need to be
connected to the 2 pin connectors
coming from the console.
Note: Either harness coming from the
console will work on the right or left
side grip pulse wire coming from the
handlebars.
5. Connect the Speed Control harness
(23A) and (23B). This is a 3 pin
connector coming from the right side
handlebar. Match the colors of the
wires coming from the handlebar
with the same colors coming from
the console.
6. Connect the Incline Control harness
(24A) and (24B). This is a 3 pin
connector coming from the left side
handlebar. Match the colors of the
wires coming from the handlebar
with the same colors coming from
the console.
7. Carefully tuck the wiring harnesses into
the back of the console and inside the
console bracket tube. Once all wires
are out of the way re-install the 6
screws removed in the first step and
tighten with a Phillips screw driver.
Step 5: Secure Console Angle (Fig 5)
1. Make sure the angle of the console
and cup holders is correctly adjusted
to match the handlebars and then tighten
the 4 screws under both sides of the
console bracket tube using the 5mm
Allen Wrench.
Step 6: Plastic Cover Assembly (Fig 6)
1. Attach the right and left side base
covers using Phillips screw (19).
Step 4
Step 5
Step 6