LifeSize Multipoint-12, Руководство по установке

Страница: 22 / 49

14 LifeSize Multipoint Installation Guide
LifeSize Multipoint Unit Initial Configuration
L
IFE
S
IZE
M
ULTIPOINT
U
NIT
I
NITIAL
C
ONFIGURATION
Initial monitoring and administration of the LifeSize Multipoint unit are
performed from a remote PC via a serial connection. This allows you to access
the boot configuration menu of the LifeSize Multipoint unit. At power-up, the
LifeSize Multipoint unit goes through the following boot phases:
Auto-boot —The embedded operating system initializes and displays
basic information.
Configuration menu —A 6-second countdown allows you to enter
the configuration menu.
Initialization —The LifeSize Multipoint unit completes its boot
sequence and is ready for operation.
Note
You can perform serial port configuration of the LifeSize Multipoint unit
only at startup, during a short period indicated by a 6-second countdown. Once the
initialization phase is complete, the only way you can access the configuration
menu is by restarting the LifeSize Multipoint unit.
C
ONNECTING TO A
PC
This section describes how to use the serial port connection to configure the
LifeSize Multipoint unit with an IP address.
Procedure
1
Locate the terminal cable shipped with the LifeSize Multipoint
unit.
2
Connect the end labeled PC to the serial port on the computer.
3
Connect the end labeled Unit to the upper serial port connector
on the LifeSize Multipoint unit front panel.
Note
The PC terminal should have an installed terminal emulation application,
such as HyperTerminal.