LifeSafety Power FlexPower Netlink NL2, Инструкция по установке и эксплуатации

Страница: 16 / 41

Netlink Installation and Operation Manual
12 13
Installation and Operation
2.2.3 Time
Settings
The Time Settings block (See Figure 2 .5 previous page) is where the time and date are programmed into the Netlink . First, select the
correct time zone from the drop down list and click Submit . After the time zone is set, the time and date can be set one of three ways:
Manual Entry
Enter the correct time and date in the following format and click the "Submit" button:
For Date:
YYYY MM DD
For Time: HH MM SS
i
ALWAYS enter two digits in time field . . ie ., 7AM = 07, not 7
The new date and time will take effect immediately .
Sync With Computer
The "Sync Date/Time with computer" button will set the date and time of the Netlink to match the computer currently being used to
access the Netlink . The new date and time will take effect immediately .
Using an NTP Server
The NTP Server fields allow you to enter one or two NTP servers for automatic setting of the time and date via the internet . The
Netlink must be configured for internet access before this setting will work . Either the IP address of the server or the DNS name
of the server may be entered . After entering at least one server, click the "Get GMT Time" button to set the Netlink time and date .
Depending on server traffic, it could take several seconds for the time setting to complete .
2.2.4 MSM Settings
These settings are used when connecting the NetLink to an MSM Enterprise server . Enter the IP address of the MSM Server in the "IP
Address" field . Set the Port number as appropriate (typically 9888) . Click Submit when done to save the settings . Consult the MSM
Enterprise manual for more information .