Flip the Master Power Switch that is located at the front of the treadmill to the ON
position. Before beginning a workout session ensure that the Safety Tether Key is
properly placed onto the yellow rectangle at the top of hand rail and the Safety Clip is
securely attached to an article of your clothing.
1. Plug in the power, turn on the power switch, the display shows the program code first,
then the beep will enter the manual standby mode after the full display: SPEED displays
0.0; TIME displays 0:00; DIST displays 0.00; CAL displays 0.
2. In the manual standby mode, by pressing the MODE button (M), you can select to run
according to the preset time or preset distance or preset calories. The time is counted, the
second ":" flashes; the countdown, the second is quiet.
3. In the standby mode, press the program key (P) to select the automatic standby mode
P1---P6 (6 automatic modes) and manual standby mode.
4. In the automatic standby mode, the countdown is displayed according to the time. The
initial time is 30:00, flashing, and the running time can be preset by the acceleration/
deceleration button to 5:00---99:00, and the time is minute.
5. In standby mode, press START/STOP button and it will run in the corresponding mode.
6. When running in various modes, the initial count must be 3 seconds (speed display
box), and the buzzer sounds 3 times.
7. In the operation mode, the MODE button (M) and the program button (P) are invalid. The
running speed can be set by acceleration/deceleration 1.0---8.0 KM/H/(1.0---8.0 KM/H).
8. In the automatic mode, there are 6 automatic modes, each of which is a 20-shot. The
specific operation mode of the automatic mode is shown in the attached table.
9. In the automatic mode, every time the switching speed is reached, a beep will be given
3 seconds in advance to prompt the user.
B. When running according to the preset distance, the initial value is 1.00, which can
be adjusted to 0.50-1.00-1.50...-65.0 by the acceleration/deceleration key. The
increment and decrement is 0.5 each time, and the unit is KM. The time and calories
will be counted down by distance. The distance counts down to 0.
C. When running according to the preset calorie, the initial value is 50. It can be
adjusted to 10-15-20---995 by the acceleration/deceleration button (addition and
subtraction to 5 each time), and the calorie will be counted down. The time and
distance are Run by. The calorie countdown to 0 stops.
D. When the initial operation is performed by manual standby, the time, distance and
calories are all in line, and the machine stops in 60 minutes.
A. When running according to the preset time, the initial time is 30:00. It can be
adjusted to 5:00---99:00 by the acceleration/deceleration button. The countdown will be
based on time, and the distance and calories will be operated. The time is up to 0 stop.
OPERATING INSTRUCTION
- 10 -
- 11 -
Panel & Remote Control
Operational Details
program on/off
mode slowly stop
speed-
speed+
NOTE: Always stand on the side rails when you start the treadmill, never start the
treadmill while you are standing on the running belt.
