14
MAINTENANCE
Cleaning
The treadmill can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the treadmill after each use.
Be careful not get excessive moisture on the computer display panel as this might cause an
electrical hazard or electronics to fail.
Please keep the treadmill, specially, the computer console, out of direct sunlight to prevent
screen damage.
Please inspect all assembly bolts, nuts, and screws on the machine for proper tightness
every week.
Storage
Store the treadmill in a clean and dry environment away from children.
TROUBLESHOOTING
PROBLEM:
Treadmill running belt slips or is not centered on rear roller.
SOLUTION:
Refer to “Adjusting the Running Belt” section on page 13.
PROBLEM:
There is no display on the computer console.
SOLUTION:
Remove the computer console and verify the wires that come from the
computer console are properly connected to the wires that come from the handlebar.
SOLUTION:
Check the batteries are correctly positioned and battery springs are proper
contact with batteries.
SOLUTION:
The batteries in the computer console may be dead. Change the new
batteries.
PROBLEM:
There is no heart rate reading or heart rate reading is erratic or inconsistent.
SOLUTION:
Make sure that the wire connections for the hand pulse sensors are secure.
SOLUTION:
To ensure the pulse readout is more precise, please always hold on to the
handlebar grip sensors with two hands instead of just with one hand only when you try to test
your heart rate figures.
SOLUTION:
Gripping the hand pulse sensors too tight. Try to maintain moderate pressure
while holding onto the hand pulse sensors.
PROBLEM:
The treadmill makes a squeaking noise when in use.
SOLUTION:
The bolts may be loose on the treadmill,
please inspect the bolts and tighten
the loose bolts.
