13
ADJUSTMENTS
Adjusting the Tension Control Knob
To increase the load, turn the Tension Control Knob in
a clockwise direction.
To decrease the load, turn the Tension Control Knob
in a counterclockwise direction.
Adjusting the
Incline Adjustment Frame
Place one hand on the rear end of the Main Frame.
Lift the rear end of the Main Frame up and then
remove the locking Pins from the Main Frame and
Incline Adjustment Frame. Adjust the Incline
Adjustment Frame to the desired position and insert
the Locking Pins into the holes on the Main Frame and
Incline Adjustment Frame that were removed.
Adjusting the Running Belt
The Running Belt is adjusted at the factory; it may
come loose during transportation and from use. After
prolong use of running, the belt will stretch out. If the
Running Belt is shifting to the left, using the Allen
Wrench provided, turn the left Rear Roller Adjustment
Bolt 1/4 turn in a clockwise direction. Try running
again; you should see the belt start to correct itself by
moving back toward the center. Repeat the above
procedure until the running belt is centered. If the
Running Belt is shifting to the right, using the Allen
Wrench provided, turn the right Rear Roller Adjustment Bolt 1/4 turn in the clockwise
direction. Try running again; you should see the belt start to correct itself by moving back
toward the center. Repeat the above procedure until the running belt is centered.
If the Running Belt is slipping during use, using the Allen Wrench provided, turn both left and
right Rear Roller Adjustment Bolts 1/4 turn in the clockwise direction for the same distance,
you should now walk on to the running belt to determine if the Running Belt is still slipping.
Repeat the above procedure until the Running Belt is not slipping.
Tension Control Knob
Locking Pin
Rear Roller Adjustment Bolt
