LIFEFIT TM-3100, Руководство пользователя

Страница: 28 / 43

Layout:
Take out the safety screw and put down the machine slowly. Tighten the mounting
screw and connect the machine.
7. Checking V-belt and treadmill settings
If you seem to slip the treadmill, the next steps will determine which part is a release
and needs to tighten, if it's a running belt or a V-belt on the engine.
1.
Turn off the main switch off and unplug the power cord (out of the socket). Loosen
the side bolts on the engine guard and take down the cover.
2.
Turn on the treadmill again and set the speed to approximately 3km / h. Stand on
the belt and pull it firmly (pressure) to stop it.
3.
If the belt is paused along with the front roller, it means that is neccessary has to
be tensioned the V-belt.
4.
If the treadmill (area) is stopped but the front roller is still spinning it means After
completing this check and setting, screw the engine protection cover.
8. Adjustment of the treadmill and adjustment the treadmill
deviation
Turn the two screws at the ends of the belt in the same direction by half a turn. If the
belt area still slips, repeat the previous step. At this adjustment, you can start the belt
at a speed of approximately 5-6 km / h.
a) Belt tension - screw in clockwise direction.
b) Loosen of the belt - screw bolt counterclockwise.
During the use of the belt, the running surface may deflect to the sides. In this case,
you must re-center it by following these steps:
1.
Place the belt on a horizontal surface and set the speed to approximately 5-6
km/h.