6
1.2
Setup
Read the Operation Manual before setting up the Inclusive Recumbent Lifecycle
®
Exercise Bike.
Electrical Power Requirements
An optional external power supply is available for the Inclusive Recumbent Lifecycle Exercise Bike. The external power
supply requires an AC power supply according to the electrical configurations listed in the chart below.
NOTE:
Do not modify the plug provided with this product. If the plug does not fit into an available electrical outlet, have a prop-
er outlet installed by a qualified electrician.
Where to place the Inclusive Recumbent Lifecycle Exercise Bike
Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See Section 3, titled
Specifications,
for the dimensions of the product footprint (assembled dimensions). Allow a distance of 21 to 30 centime-
ters ( 8 to 12 inches) between the bike and other objects or surfaces on either side. Allow a distance of 1 meter ( 3 feet )
from the front or rear of the bike to any other object or surface.
How to stabilize the Inclusive Recumbent Lifecycle Exercise Bike
After placing the bike in position, check the unit’s stability by attempting to rock it from side to side. Any slight rocking
indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut
(A) with an open-end M17 wrench, and rotate the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat
the adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the
stabilizer bar.
Check for Battery power
The Inclusive Recumbent Lifecycle Exercise Bike console is powered by a rechargeable 6-volt battery. Check the battery
by pressing and holding the power on/off key. The console should beep and light up. The Message Center on the
console will display a prompt to set up a workout. If a prompt doesn’t appear or initializing doesn’t begin, mount the
Inclusive Recumbent Lifecycle Bike and begin pedaling. The console should light up and programming a workout can
begin. Pedal for 20 minutes at 40 RPM or faster during a workout to charge the battery. The pedal action during work-
outs keeps the battery charged. If the Inclusive Recumbent Lifecycle Exercise Bike is powered by the external 36V DC
power supply, battery maintenance is automatic and pedaling is not required.
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8
