6
Powering up the System
Important !
Make sure a switch does not control the outlet and that it is not part of a ground fault interrupt circuit (GFIC).
1. Simply plug the transformer into an available standard outlet.
2. Turn the Power switch on the back of the panel to ON. The panel voice announces “Hello, system two,
zero is ok” and the Power/Home/Away light turns on.
Signaling for Help
Pushing the button on your portable help button or the CALL button on the control panel places an
emergency call to your emergency phone numbers.
Signaling for Help With Your Personal Help Button
Your personal help button can be used in a number of ways. It can be worn
like a watch, a pendant or on a belt. It can even be mounted on a wall. See
the Installation Instructions that came with your help button for complete
instructions on assembling it.
To signal an emergency with a portable help button
• Press and hold in your help button until the red light blinks.
Signaling for Help With Your Panel CALL Button
If you are near the LifeCall 7000 panel during an
emergency or your personal help button is unavailable,
you can use the CALL button on the panel to signal for
help.
To signal an emergency with the CALL button:
• Press the panel CALL button once.
After You’ve Signaled for Help
• The Status light on the panel begins blinking.
• The panel calls VOXCOM’s Emergency Response Centre.
• The panel announces “Contacting emergency phone number, please remain calm.”
• The panel reports an alarm to VOXCOM.
• The operator at the monitoring station can now talk with you.
The Master Access Code
The Master Access Code is needed when entering programming mode and when using the Check-in
feature. (
Default Master Access Code is 1234
). If you wish to change your Master Access Code,
contact your dealer or installer.
Record your Master Access Code here:
__ __ __ __ __ __
