Life Span ZOOM, Руководство пользователя

Страница: 27 / 33

LIFESPAN ZOOM Page 26
This treadmill is designed to keep the belt reasonably centred while in use. It is normal
for some belts to drift near one side while the belt is running with no one on it. After a
few minutes of use, the belt should have a tendency to centre itself. If during use, the
belt continues to move toward one side, adjustments are necessary. The procedures
are as below:
First set speed at lowest position.
▲
Second check the belt shifts to which side.
▲
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
6mm Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten
the left bolt and loosen the right bolt by using 6mm Hexagonal Wrench, until the belt
is centered. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is
important to adjust the belt in half turn increments. Over adjusting the belt can cause
damage to the mat.
6. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine
will turn off automatically to prevent any injuries to the user and to prevent damage to
the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the
self-checking analyse (please refer to 4.3 Self-Checking ) to distinguish what type of
error problem the machine is encountering.
Before attempting any work on the treadmill, ensure that the power is off
and the plug is removed from the power point.
Do not use extension leads as it may lead to power decrease and failure.
6.1 Alarm signals
E1: No feedback from controller or speed sensor
1. Check the condition of cables and ensure that all plugs are connected between the
motor controller and display.
2. Check that the speed sensor and magnet are in correct alignment and that there
are no obstructions on the magnet. (The magnet can be found on the front roller
near the motor belt).