Kit No. GK62-00002-0070
Document No. M051-00K62-A199
5
08 Sep 2008
Fig 12: installing the snap ring
Fig 13: pull the shaft collar in the direction of the arrow
Fig 14: tightening the shaft collar
17.
Install the new snap ring (see Figure 12)
18.
Pull the rocker arm against the snap ring.
19.
Slide the shaft collar tightly against the
Oilite washer and rocker arm housing (see
Figure 13).
20.
Tighten the setscrew on the shaft collar
(see Figure 14).
21.
Swing the rocker arm to verify free
movement. This will also provide
assurance that the Loctite has not seized
the bearing and sleeve together.
22.
Reattach the user arm and pedal to the
rocker arm.
23.
Reattach the lower rocker arm cover.
24.
Reattach the outer deadshaft cover.
25.
Repeat steps 1-23 with the other rocker
arm. The Loctite on the first side will be
curing while the second rocker arm kit is
being installed.
26.
Allow the Loctite on the second rocker
arm kit to cure undisturbed for at least 30
minutes.
