21.
Install the LEFT REAR ENDCAP (21) using two SCREWS (22).Tighten the SCREWS securely. Do not overtighten
the SCREWS.
NOTE:
BE SURE THE LOCATOR CLIP IS ENGAGED TO THE LEFT SIDE EXTRUSION AS SHOWN IN THE
DETAIL BELOW.
22.
Install one FOAM STRIP (24) between the LEFT SIDE RAIL and LEFT SIDE EXTRUSION.
Repeat to install the RIGHT SIDE EXTRUSION (25) to the RIGHT SIDERAIL (U).
NOTE:
BE SURE THE TREADMILL IS IN THE FINAL LOCATION FOR USE BEFORE INSTALLING THE LEFT
AND RIGHT EXTRUSIONS.
23.
Install the LEFT (26) and RIGHT (27) UPRIGHT COVERS using two SCREWS (22) and one SCREWS (28) each.
Tighten the SCREWS securely. Do not overtighten the SCREWS.
Press inward on the UPRIGHT COVER and engage the pre-installed SCREW (V) located at the rear of each
UPRIGHT COVER.
24.
Reinstall the MOTOR COVER (B) using the six previously removed SCREWS (A). Tighten the SCREWS securely.
Do not overtighten the SCREWS.
25.
Install the GROMMETS (29) into the screw holes of the INNER HANDRAIL COVERS.
26.
Install the CUP HOLDERS (30).
NOTE:
BE SURE THE TABS ENGAGE FIRST AND TILT INTO PLACE.
27.
The treadmill striding belt must be “walked-in” for five minutes after assembly is complete.
Plug the treadmill into an appropriate outlet. Turn the treadmill on at the on/off switch. Select QUICK START from
the console. Increase the speed to 3 mph (4.8 km/h). Start walking in the front left corner of the walking surface
and drift to the back, move to the center of the deck and walk towards the front, and finally walking to the right
corner and drifting to the back. Continue pattern for five minutes.
28.
Refer to the Operation Manual for power requirements, proper line cord routing, and other critical product informa-
tion before connecting the treadmill to a power source. A digital version
of the Operation Manual can be
found on the attached
CD.
27
20
21
23
B
U
4
1
22
22
28
26
22
24
V
S
A
T
22
30
30
29
21
23
Содержание 95T
Страница 1: ...95T Treadmills Assembly Instructions ...
