Lifan Power USA. 2250 Industrial Park Rd. Van Buren, AR 72956
PH 866-471-7464 www.lifanpowerusa.com
26
Do not mix different grades of oil or detergents.
2. Replacement of old engine oil
Replacing engine oil: This unit comes with pre-drain hoses already installed from
the factory for ease of service. See photo on next page.
● Start the engine for several minutes to increase the temperature of the engine oil and
then stop the engine after warm-up. .
●Place pan under the oil drain hose. Open oil drain valve to drain out all engine oil.
● Close oil drain valve and replace with recommended oil amount.
●
Start engine and allow new oil to circulate and fill oil filter for three minutes.
Make sure there are no visible oil leaks!
●
Shut down unit and top off oil as needed. Oil level should be between A and B marks
on the dipstick, it is preferred that the level be close to B mark but not over!
Coolant Drain Hose Oil Drain Hose
3. Replacement of used oil filter with new oil filter
Replace old oil filter after the engine has cooled. The replacement cycle should be
followed according to the maintenance cycle schedule.
Steps for replacement
：
● Use oil filter wrench to remove old oil filter. Turn to the left to loosen.
● Before installing new oil filter, coat gasket surface with a thin layer of oil before
installation.
