24
Pre-Operating Instructions: Connecting
Inlet & Outlet Hoses
CONNECTING INLET HOSE:
1. Connect Inlet Hose to Inlet Hose Connection on Pump. Tighten
securely.
2. Connect alternate end of Inlet Hose to a water tap. The water tap
must deliver at least 20psi (pounds per square inch).
3. Insufficient water supply will damage your pump. Make sure the water
supply is steady and is 20% over the rated flow of your pump (2.5
gallons per minute).
NOTE: Under NO circumstance should the pressure washer be used
as a self-prime from a water vessel.
CONNECTING OUTLET HOSE:
Outlet House must be a High Pressure Hose. NOTE: the Outlet Hose (High
Pressure Hose) provided is the BLACK hose. The Outlet or High Pressure
Hose must be checked for any wear or leakage. Replace any damaged
high pressure hoses.
1. Connect the Outlet Hose to Outlet Hose Connection on Pump. Tighten
securely.
2. Connect alternate end of Outlet Hose to Spray Gun as shown below.
Tighten securely.
