Libelium Waspmote Smart Parking v2, Техническое руководство

Страница: 19 / 155

Smart Parking node
‚
Step 4: Insert the screws and tighten them halfway.
Figure : Screws in their position
‚
Step 5: Finally, tighten the 4 screws fi rmly. Do not use the maximum pressure (do not go all the way with the
screws), because the o-rings could be ejected from the screws, and then the waterproof feature would NOT
be valid. Besides, do not screw too hard and keep on screwing, because the screws could carve the female
sockets, expanding their inner diameter; this would cancel the waterproof quality too.
Libelium manufactures and provides all nodes con fi gured after following all explained steps, so the node is "ready
to install". By factory default, all nodes are con fi gured with their unique LoRaWAN EU I and random private keys.
On the other hand, if di ff erent LoRaWAN parameters are desired, “ Smart Devices App ” must be used to change the
settings and repeat the previously explained steps.
3.5.3. "Magnet start-up" process
Once the node has been set to "ready to install" state and it has been closed and placed on the parking slot, the
"magnet start-up" must be done. This process consists on resetting the device using the magnet for 3 consecutive
times. Each magnet reset must be separated by at least one second period.
The best way to proceed with the magnet is to go over the enclosure from left to right in a one-motion movement.
Then wait for at least one second (although you can wait more) and proceed again until you complete 3 magnet
resets.
Figure : Magnet reset
- 18 - v7.5