14
INSTALLATION
EN
Connecting the Hose to the
Appliance
Screw the water inlet hose to the water inlet valve
on the back of the appliance.
• Do not connect the hose to the hot water supply
for models with one water inlet. Connect to the
cold water supply only.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. In
case that the tap is square or too big, remove the
guide plate before inserting the tap into the
adaptor.
Installing the Drain Hose
Before connecting the drain hose, check your drain
hose model and choose the correct instruction.
Installing the Drain Hose with
the Elbow Bracket
The drain hose must not be placed higher than
120
cm
above the floor. Water in the appliance may not
drain or may drain slowly.
• Securing the drain hose correctly will protect the
floor from damage due to water leakage.
• If the drain hose is too long, do not force the
drain hose further into the drain outlet. This will
cause abnormal noise.
• When installing the drain hose to a sink, secure it
tightly with the some string, cable tie, or chain.
NOTE
• The discharge height should be approximately
90 - 120 cm
from the floor.
FP
FP
