LG TD-V700E, Инструкция по использованию и уходу

Страница: 9 / 28

I
nstallation Instructions
8
Note
Vent end will face to the outside home and
improper taping and unstable installation of vent will
cause undesirable drying performance.
Note
During transportation side cap can come out slightly.
If that is so, push and fit it to the hole to prevent
possible lint leakage.
STEP 2 Connecting the Exhaust
and Venting System.
In addition to the following warnings, please refer to
manual section on Exhaust Requirements and
Maintenance.
IMPORTANT : To reduce the risk of fire,
combustion, and gas accumulation, the dryer must be
vented to the outdoors. Please follow the instructions
(and all others in this manual) very carefully.
1.
Remove Duct Connector.
2. Remove the right (or left) Side Cap by (-) driver.
3.
Assemble the Duct Connector to the right hole
(or left hole) and close the back hole by Side Cap.
•
Do not use thin plastic or foil ducting.
•
Use 4" (10.2 cm) diameter rigid or flexible metal
duct (note: venting materials are not supplied with
the dryer, and you should obtain the venting
materials necessary for proper installation)
•
Position the Dryer such that the exhaust duct run is
as short as possible.
•
Clean old ducts before installing this dryer
•
The male end of each section of exhaust duct must
point away from the dryer
•
Use as few elbow joints as possible.
•
Use duct tape on all duct joints
•
Insulate ductwork that runs through unheated
areas in order to reduce condensation and lint
•
PLEASE BE AWARE THAT FAILURE TO
EXHAUST THE DRYER CORRECTLY WILL
VOID THE DRYER’S WARRANTY.
To change duct direction following the belows.
• Use a heavy metal vent.
• Do not use a plastic vent.
• Do not use a metal foil vent.
• Failure to follow these instructions can
result in death or fire.
• Clean old ducts before installing this dryer.
WARNING!
Duct Connector
Duct Connector
Side Cap
Side Cap
Installation
Instructions