Owner's Manual
9
Operating Instructions
Wireless Remote Controller
The controls will look like the following.
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation (Only heat pump)
Signal transmitter
Operation Mode
ON
OFF
STEP
CANCEL
AUTO CLEAN
SET
ON/OFF BUTTON
Used to turn off/on the unit.
ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
AUTO CLEAN BUTTON
Used to set auto clean.
AUTO CLEAN
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
TIME SETTING BUTTONS
Used to adjust the time.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
ON
OFF
TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
SET
CANCEL
RESET BUTTON
Used prior to resetting time.
LED LUMINOSITY BUTTON
Used to adjust LED luminosity.
PLASMA BUTTON
Used to start or stop the plasma-purification.
JET COOL BUTTON
Used to start or stop the speed cooling.
The Jet Cool operates fan in super high speed
in cooling mode.
SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
2nd F BUTTON
Used prior to using modes printed in blue at the bottom
of buttons.
INDOOR FAN SPEED SELECTION BUTTON
Used to select fan speed in four steps low, medium,
high and natural wind.
HORIZONTAL VANE CONTROL BUTTON
Used to set the desired vertical airflow direction.
VERTICAL LOUVER CONTROL BUTTON
Used to set the desired horizontal airflow direction.
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
To use the functions printed in blue at the bottom of the buttons press 2
nd
F button first and then the required function
button. Pressing the 2
nd
F button activates the blue printed function of the respective button. To cancel the function
press the 2nd F button again else it will automatically cancel if remains idle after 10 seconds.
NOTE
