14
INSTALLATION
UNPACKING THE STYLER
• Remove tape and any temporary labels
from the Styler before using.
Do not remove any warning labels, the model
and serial number label, or the Tech Sheet
that is located under the front of the Styler.
• To remove any remaining tape or glue, rub
the area briskly with your thumb.
Tape or glue residue can also be easily
removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
• Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue.
These products can damage the surface of
the Styler.
WARNING
y
Use two or more people to move and
install the Styler.
Failure to do so can result
in back injury or other injury.
y
The Styler is heavy. Use the wheels at the
bottom of the product to move it.
Push the
Styler slowly from about halfway down the
front side.
y
Keep the Styler upright when moving it.
If
you lay the Styler on its side, refrigerant may
leak and cause the appliance to malfunction.
y
Keep flammable materials and vapors,
such as gasoline, away from the Styler.
Failure to do so can result in fire, explosion,
or death.
CHOOSING THE PROPER LOCATION
Electricity
Install where an outlet is easily accessible.
Use an individual, grounded outlet:
220-240 Volts, 50 Hz, AC, 15 Amps
minimum.
WARNING:
Do not plug in multiple appliances in the same outlet
with the Styler.
Overloading house wiring can cause a fire hazard.
To reduce the risk of electric shock, do not install the Styler in a
wet or damp area.
Floor
Floor must be level and solid enough to support 183 lb (83 kg).
Adjust the leveling legs to compensate for any unevenness in the floor.
Do not install on a platform or a weakly supported structure.
Ambient temperature
Temperature must be between 50°F (10°C) and 95°F (35°C).
If the ambient temperature is too low or high, performance may be affected.
Do not install in direct sunlight or where the temperature may fall below
32°F (0°C).
Clearances
Allow at least 18 in. (46 cm) in front to open the door.
Allow at least 2 in. (5 cm) on both sides and between the back of the Styler
and the wall. Allow at least 7 3/4 in. (20 cm) between the top of the Styler and
any overhanging shelves or cabinets.
If the Styler is too close to adjacent items, performance may decrease and
electricity consumption may increase.
Содержание Styler S3 F Series
