Hook Up An Over-The-Air Antenna
Connect an off-air antenna.
Page 10
Flat wire
(300 ohm)
300/75 ohm
Adapter
Antenna
1
2
3
4
Locate the Antenna/Cable jack on
the back of the TV.
Connect the antenna that runs from
the wall directly to this jack,
according to one of the connection
diagrams shown to the right.
Remove the back of the remote
and put in two AA batteries.
Plug in your TV. This TV is
designed to operate on standard
current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC
Current.
Typical
TV Back
-V
S id eo n
I
M.P.I.
R Audi I
o n L
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
Typical
TV Back
S-Vid o n
e I
M.P.I.
R Audio I L
n
Antenna
Cable
Component Video Input
R Audio In L
R Audio L
Video In
Y
Pr
Pb
Matrix Out
If you have a 75 ohm RF cable, then you
don’t need any adapters!
A 300 to 75 ohm adapter is not included
with the LG TV.
The wire that comes from an off-air antenna or cable service provider. Each end looks
like a hex shaped nut with a wire sticking through the middle, and it screws onto the
threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They
are usually about an inch long with two screws on one end and a round opening with a
wire sticking out on the other end.
Mini Glossary
75 OHM RF
CABLE
300 TO 75
OHM
ADAPTER
120 Volt
60 Hz AC
Back of the
Remote