15
INSTALLATION
EN
• In case of the top plate size is 600
mm
• In case of the top plate size is 550
mm
4
Fasten the 2 screws that were
removed earlier from the appliance
to the stacking kit.
5
Use the 4 screws in the accessory box
(16 mm) to assemble the washing
machine rear cover and stacking kit.
6
The procedure for the opposite side
will be the same.
Installing the Optional Drain
Hose
Normally, condensed water is pumped
up to the water container where water is
collected until manually emptied. Water
can also be drained out directly to a
mains drain, especially when the
appliance is stacked on top of a washing
machine. With the connecting elbow or T
piece of the mains drain hose, simply
change the water path and re-route to
the drainage facility as below:
1
Separate the anti-backflow lid
a
and
the water container hose
b
from the
connecting elbow or T piece.
2
Attach the anti-backflow lid
a
to the
head of the connecting elbow or T
piece and then connect the optional
drain hose
c
to the opposite side of
the connecting elbow or T piece.
CAUTION
• If the optional drain hose is installed in
a way that leaves it bent or pinched,
drainage may not function properly.
b
a
a
c
