Installation instruction
Owner’s & Installation Manual
23
ENGLISH
Installation instruction
22
Wide Wired Remote Controller
Installer Setting-Celsius / Fahrenheit Switching
Function Code
conversion mode value
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display “01:01”.
1
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
5
Repeat pressing button to select
Function code 12.
Ex) Fahrengeit Setting
2
Select Temperature unit mode by
pressing button.
(01: Celsius, 02: Fahrenheit)
3
Press button to save or release.
4
This function is used for switching the display between Celsius and Fahrenheit.
(Optimized only for U.S.A)
❊
Whenever press
button in Fahrenheit mode, the temperature will increase/drop 2
degrees.
Function Code
Zone type value
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display “01:01”.
1
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
5
Repeat pressing button to select
Function code 13.
Ex) Setting the Zone Type as "New"
2
Select Zone Type by pressing
button
(00:Old, 01:New)
3
Press button to save or release.
4
Installer Setting-Zone Type Setting
This function is only available on some products.
It is possible to setup zone new type or old one of the product which is available to install the damper
controller.
If you set zone number incorrectly, the product may malfunction especially in zone control.
This function must carried out by a certificated-technician.
CAUTION
