7
ENGLISH
_ind
ex
•
When installing on a gypsum board or medium-density fiberboard
(MDF) wall, fasten the screws to the studs that support the wall. If
there are no studs, check the distance from the inner wall before
installing.
-
30 mm or below: Install directly on the inner wall using a 65 mm
screw.
-
30 mm or above: Install using a separate hanger.
Wall
•
When installing the wall mount, check the positions of the wooden
studs using a stud finder. Then, fasten the screws on at least two
separate studs before proceeding.
Wall mount
Stud
•
When installing the product on wall material not designated,
install the product so that each location can withstand the pull out
load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
•
Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill.
Tools you will need
•
Phillips head + driver (manual or motorized), Ø 3/6/8 mm Drill bit,
Level, Stud finder, Drill
How to attach to masonry walls
Please follow the below direction.
1 Use a drill bit Ø 8 mm to drill a hole for the anchor location within
a depth of 80 mm to 100 mm.
2 Clean the drilled hole.
3 Insert the sealed wall mounting anchor to the hole. (When
inserting the anchor, use a hammer.)
Wall mounting anchor
4 Set the wall mount on the wall by aligning to the location of the
hole. And, set the angle adjusting part to face upward.
Wall mount
5 Align the wall mounting screw to the hole and tighten it. Then,
fasten the screws at torque of 45 kgf
/
cm to 60 kgf
/
cm.
Wall mounting screw
