10
Indoor Unit
Installation
Fixing Indoor Unit
• Drill the piping hole with a Ø50mm(2”) hole core drill. Drill the piping hole at either the right or the left with the
hole slightly slanted to the outdoor side.
5-7mm
(3/16"~5/16")
Indoor
WALL
Outdoor
Plastic anchors
INSTALLATION GUIDE MAP
10mm
INST
ALLA
TION GU
Plastic anchors
INST
ALLA
TION GUIDE MAP
INST
ALLA
TION GUIDE MAP
Hanger hole
(Rear side of
the product)
INST
AIIA
TION GUIDE MAP
3. Make a hole with a diameter of
6mm(0.25”) and depth of 30-35mm(1.25"
to1.5") by piercing a screw point.
5. Drive the four plastic anchors into drilled
points.
7. Hang the hole of product at the upper
screws, and remove the map.
9. Check to ensure the unit is secure.
1. Attach an Installation guide map on the
desired surface.
2. Look at suited horizon by horizontal
meter on the horizontal setting line, and
fix lightly the map by adhesive tape.
4. Drill the Pierced part as a diameter of
50mm(2”) for connecting piping. (In case of
piercing rear surface)
6. First, Drive the two points of the upper
parts by screws. (Leave 10mm(0.5”) for
hanging the product)
8. Secure the lower screws first, and then
completely tighten the upper screws.
10. Once completed, connect the pipe and
the wire. (Refer to installation manual)
Horizontality
INST
ALLA
TION GUIDE MAP
If the split type Indoor unit is installed in a wall having hole or open-
ing near by or back side of the unit, then the air from other side of
the wall can come inside the condition space through that hole/
opening. That air can cause unwanted dew/ water droplet formation
when it comes in contact with body of the indoor unit. So all hole or
opening on the wall must be blocked very well to avoid water
Dripping from the body of the unit.
Drill a Hole in the Wall
