- 17 -
TROUBLE SHOOTING GUIDE
3. Protect Mode
(1) Symptom
¯
Will not fully turn on
¯
The Relay "clicks"
¯
Front LED changes from Green to Red
Is output the normality Low/High
Replace
Y-Board.
After connecting each connector well,
Is the output voltage good after
removing P1, 2, 101, 300, 701, 702
(In case of open, replace fuse)
Replace
Z-Board.
Check Fuse(FS1, FS2) on Z-B/D?
(In case of open, replace fuse)
Is the output voltage good after
removing P1, 2, 3, 4, 6, 7 connector
Is the output voltage good after
After crisis COF of each board, check the normality operates.
If in case normality operates, correspondence COF Fail is
replace the module.
COF of X, Y, Z?
Содержание MU-50PM10
