9
Installation
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
VAHU DOWNFLOW CONVERSION KIT
Figure 6: Vertical Brackets.
Vertical
Bracket
Rear
Bracket
Side
Brackets
Front
Bracket
Figure 7: Horizontal Brackets.
Figure 8: Route Wiring.
Sensor
Wiring
Figure 9: Reinstall Coil Assembly.
Evaporator
Coil/Drain
Pan Assembly
Vertical Downflow Installation - continued
7. Install the conversion kit left and right rear vertical brackets in the rear corners of the cabinet (Figure 6).
8. Position the rear horizontal bracket on the two vertical brackets and secure with screws (Figure 7).
9. Position the left and right horizontal side brackets and secure with screws (Figure 7). The brackets are not left/right hand
dependent.
10. Position the front horizontal bracket and secure with screws (Figure 7).
11. Confirm all bracket screws are secure and the bracket assembly is correctly positioned to support the evaporator coil/drain
pan assembly.
12. Route the wiring for the pipe in and pipe out sensors (Figure 8).
13. Carefully slide the evaporator coil/drain pan assembly back into the cabinet (Figure 9). Confirm the
assembly is against the rear panel of the cabinet.
