19
REFRIGERATOR INSTALLATION
• Place washer between refrigerator door and middle
hinge and re-attach Hinge Pin to Hinge Bracket with
1/4-in.socket wrench.
NOTE
: Bracket has been flipped, but Hinge Pin stays in the
same orientation with its hexagonal end facing upward.
• Place Decorative Screw into outer hole on right side
of housing.
• Attach cover on the right side. Cover is force-fitted
REATTACHING FREEZER DOOR
• Put freezer door down over the Hinge Pin on the Middle
Hinge Pin Bracket
• Place Upper Hinge’s Pin in the top of freezer
door and line up the Upper Hinge with holes in top of
refrigerator. Use the 3 bolts to replace Hinge.
• Tighten bolts. Force-fit Top Hinge Cover over Top
Hinge.
• Replace cover from left side of refrigerator top
onto the right of top to cover the holes. Cover is also
force-fitted
After changing doors, make sure that the corners of
the Door Gaskets are not folded over. To ensure a
good seal, apply a small amount of silicon grease on
the corners of gaskets.
Corners
• Following illustration, flip the Middle Hinge Bracket
(Flange will now be on top) and position on left side of
refrigeratorand re-attach with two bolts and a Phillips
• Place refrigerator door down over pin on bottom hinge.
(Fig. 32).
Fig. 33
Decorative
Screw
Fig. 35
Fig. 36
Cover (on top of
refrigerator)
Fig. 37
Fig. 32
Flange
• Remove the outer lower Decorative Screw from housing
at area between freezer and refrigerator doors (Fig. 31).
(You will need this hole for the Middle Hinge Bracket).
Fig. 31
Fig. 34
screw. (Fig. 32).
