21
INSTALLATION
EN
G
LI
SH
3
Connect all the wire harnesses and the
ground screw.
4
Push the water supply tube into the hole on
the top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet
d
to connect the water
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
• Connections may vary by model.
† This feature is only available on some
models.
NOTE
• Disassembling/Assembling the Water Lines
e
Collet
f
Tube
g
Insert line
h
Clip
• Gently press the collet and insert the tube until
only one line shows on the tube.
6
Set the cover
i
in place. Insert and tighten
the cover screw
j
.
Type A
†
Type B
†
Type C
†
us_main.book.book Page 21 Thursday, January 7, 2021 5:38 PM