44
BEFORE CALLING FOR SERVICE
Problem
Possible Causes
Solutions
Oven door will not open
• Oven too hot.
• Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a
• Oven controls not properly set.
• See the
Using the Self-Cleaning Oven
section.
clean cycle
• Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes
• The self-clean cycle has been
• Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR light
• The oven door is locked
• Touch the
CLEAR/OFF
pad. Allow the oven to cool.
is on when you want
because the temperature
to cook
inside the oven has not
dropped below the
locking temperature.
“F—and a number or
• You have a function error code.
• Touch the
CLEAR/OFF
pad. Allow the oven to cool for
letter” flash in the display
one hour. Put the oven back into operation.
• If the function code repeats.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven shelves are
• The nickel shelves (if so equipped)
• Apply a small amount of vegetable oil to a paper
difficult to slide
were cleaned in a self-clean cycle.
towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam
®
or other
lubricant sprays.
“Probe” appears
• This is reminding you to enter a
• Enter a probe temperature.
in the display
probe temperature after plugging
(convection models)
in the probe.
Display goes blank
• A fuse in your home may be blown
• Replace the fuse or reset the circuit breaker.
or the circuit breaker tripped.
• The clock is in the
• See the
Special Features of Your Oven Control
black-out mode.
section.
Display flashes
• Power failure.
• Reset the clock.
Unable to get the
• Oven control pads were
• The
BAKE
and
BROIL HI/LO
pads must be touched
display to show “SF”
not pressed properly.
at the same time and held for 3 seconds.
Power outage,
• Power outage or surge.
• Reset the clock. If the oven was in use, you must
clock flashes
reset it by touching the
CLEAR/OFF
pad, setting the
clock and resetting any cooking function.
T RO U B L E S H O OT I N G
Содержание LRG30355SB - 30in Gas Range
