GRILLE ASSEMBLY
DEFROST-CONTROL
ASSEMBLY
GRILLE
FAN MOTOR
BRACKET
MOTOR
FAN
3-1 FAN AND FAN MOTOR
1. Remove the freezer shelf. (If your refrigerator has an
icemaker, remove the icemaker first).
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling the
grille forward.
4. Remove the Fan Motor assembly by loosening 2 screw and
disassemble the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket.
3-2 DEFROST CONTROL ASSEMBLY
Defrost Control assembly consist of Drefrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature.
Fuse-M is safety device for preventing over-heating of the
Heater when defrosting.
At 72°C, it turns the Defrost Heater off.
1. Pull out the grille assembly. (Fig. 1)
2. Separate the connector with the Defrost Control assembly
and replace the Defrost Control assembly after cutting the Tie
Wrap. (Fig. 2)
1. Unplug your refrigerator.
2. Pull out all of the shelves.
3. Slide a flat screwdriver (1) into the opening of the
light bulb, and pull it downwards (2).
3-3 LAMP
3-3-1 REFRIGERATOR COMPARTMENT LAMP
3-3-2 FREEZER COMPARTMENT LAMP
1. Unplug refrigerator.
2. Unlock the cover of the light bulb using your thumbs (2).
3. DISASSEMBLY
- 7 -
1
2
1
2
4. Turn the bulb counter clockwise and remove it.
5. Install the new light bulb.
6. Take the cover (1), lock the hooks (2) from the rear part
of the light bulb and push it upwards (3).
1
2
3
1
2
1
2
3. Remove the light bulb and replace it with a new one.
4. Take the cover (3), lock the hooks of it (4) and push it
upwards (5).
5. Plug the refrigerator back in.
4
5
3
Fig. 1
Fig. 2
