ENGLISH
32
PICTURE ID Settings
•
Only applies to certain models.
is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
monitor is identified by a
Set ID
. If you assign the
using the remote control, only displays with matching
and
Set ID
can be controlled remotely.
1
Assign the
Set ID
to the installed monitors as shown below.
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
2
Press the red
ON
button on the remote control to assign the
PICTURE ID
.
3
Assign the
Set ID
to the selection of your choice.
•
A set with a different
Set ID
from the
PICTURE ID
cannot be controlled by IR signals.
NOTE
•
If
PICTURE ID
is set to 2, only the upper right monitor, which has a
Set ID
of 2, can be controlled by IR signals.
•
If you press the green
OFF
button for
PICTURE ID
, the PICTURE IDs for all monitors are turned off. If you then press
any button on the remote control, all monitors can be controlled by IR signals regardless of
Set ID
.
IR & Light Sensor
RS-232C cables
PICTURE ID
ON [2]
Содержание L15
Страница 48: ......
