LG GR-359, Руководство по обслуживанию

Страница: 9 / 41

4 FAN AND FAN MOTOR
1) Remove freezer drawers.
2) Remove two cap, screws and loosen two screws in Grille Fan.
3) Pull out the Grille Fan and Shroud, F.
4) Disconnect the housing of lead wire.
5) Separate the Fan Assy.
6) Losse 2 screw fixed to the Bracket.
7) Pull out Shroud, F remove the Fan Motor Assy.
8) Separate the Motor Bracket and Rubber.
5 DEFROST CONTROL ASSY
Defrost Control Assy consists of Thermistor and Fuse, Melting.
Thermistor functions to defrost automatically and it is attached to
metal side of the Evaporator and senses temperature.
Fuse, Melting is a kind of safety device for preventing overheating
of the Heater when defrosting.
At the temperature of 72°C, it stops the emission of heat from the
Heater.
1) Pull out the Shroud, F after removing the Grille.
2) Separate the connector connected with the Defrost Control
Assy and replace new one.
6 DAMPER CONTROL
1) Remove the Cover Lamp, R and loosen 2 screw.
2) Pull the Control Box, R and separate the lead wire
housing.
3) Remove the Cover Lamp, R.
4) Separate the Insulation Multi Duct and Control Box, R.
5) Disassemble the Knob.
6) Separate the Damper Control and Control Box, R.
7) Separate the Damper Control and Resistor.
8) Disconnect the lead wire.
7 HEATER, SHEATH & HEATER, CORD-L
In this refrigerator, Heater, Sheath & Heater, Cord-L are
used for defrosting heater. During heating, the temperature
of heater rises about 300~350°C. Therefore, be careful not
to burn while servicing.
1) After removing the Grille and Shroud, separate the
Heater, Sheath by disconnecting the connectors.
2) Exchanged Heater, Sheath and connected the housing.
3) If the Heater, Cord-L is defected, disconnect the
connectors, and separate the Heater, Cord-L with
Long Nose.
4) Replace and assembly the Heater, Cord-L and connect
the connectors.
REFRIGERATOR ROOM LAMP
Heater, Sheath
Heater, Cord-L
GUIDE FAN
FAN
SHROUD
FAN MOTOR
GRILLE
Thermister
Fuse, Melting
Figure 13
Figure 14
Figure 11
Figure 12
- 8 -