12
EN
Unpacking the Appliance
Lifting the Appliance Off the Foam
Base
* This feature is only available on some models.
After removing the carton and shipping material, lift
the appliance off the foam base.
•
Make sure the tub support
a
* comes off with
the base and is not stuck to the bottom of the
appliance.
•
If you must lay the appliance down to remove
the carton base
b
, always protect the side of
the appliance and lay it carefully on its side. Do
not lay the appliance on its front or back.
*
Removing the Bolt Assemblies
1
Starting with the bottom transit bolts
a,
use
the spanner (included) to fully loosen all transit
bolts by turning them counterclockwise.
2
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
3
Install the hole caps.
•
Locate the hole caps
b
included in the
accessory pack or attached on the back.
Levelling the Appliance
Checking the Level
Levelling the appliance prevents unnecessary
noise and vibration. Check whether the appliance is
perfectly level after installation.
•
If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
Adjusting and Levelling the Feet
When installing the appliance, the appliance should
be aligned and perfectly level.
•
If the appliance is not aligned and level properly,
the appliance may be damaged or may not
operate properly.
