LG 55EJ5E, Руководство пользователя

Страница: 85 / 117

ENGLISH
47
Picture ID
Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision.
Communication is possible between a monitor with an IR receiver and other monitors using RS-232C cables. Each
monitor is identified by a Set ID. Setting Picture ID allows you to only use the remote control with monitors with a Set
ID that matches the Picture ID .
1
Assign Set ID to the installed monitors as shown below:
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
2
Press the red Picture ID On button on the remote control.
3
Make sure that the Picture ID you set is identical to the Set ID of the monitory you wish to control.
• A set with a
Set ID
that is different from the
Picture ID
cannot be controlled by IR signals.
NOTE
• If Picture ID has been set to 2, only the upper right monitor, which has a Set ID of 2, can be controlled by IR signals.
• If you press the green Picture ID Off button on your remote control, the Picture ID for all monitors are turned off. If
you then press any button on the remote control, all monitors can be controlled by IR signals regardless of their Set
ID 's.