- 18 -
LGE Internal Use Only
Copyright ©
LG Electronics. Inc. All rights reserved.
Only for training and service purposes
● In case of Edge LED module, the color coordinates is
changing by aging, so you have to use the below table.
The Time Table of color coordinates by SET Aging Time
GP3
Aging
time
(Min)
Cool
Medium
Warm
x
y
x
y
x
y
269
273
285
293
313
329
1
0 ~ 2
279
288
295
308
319
338
2
3 ~ 5
278
286
294
306
318
336
3
6 ~ 9
277
285
293
305
317
335
4
10 ~19
276
283
292
303
316
333
5
20 ~ 35
274
280
290
300
314
330
6
36 ~ 49
272
277
288
297
312
327
7
50 ~ 79
271
275
287
295
311
325
8
80 ~ 149
270
274
286
294
310
324
9
Over 150
269
273
285
293
309
323
■ In the SET applied LED module (LS5700/LM6200/LM6600/
LM7600 Series), cause of the physical characteristics of
LED Module, sets are taken a 120 minutes by aging time
to stabilize a color coordinates. So White Balance Control
equipments have to get the SET Aging Time from the SET
and then going to control the W/B by revise color coordinates
at each time
- To check the Coordinates of White Balance, you have to
measure at the below conditions.
Picture Mode : select Vivid and change
Dynamic Contrast : Off ,
Dynamic Colour : Off,
Clear White : Off
->Picture Mode change : Vidid -> Vivid(User)
(If you miss the upper condition, the coordinates of W/B can be
lower than the spec.)
5.3. Intelligent Sensor Inspection Guide
Step 1. Turn on the TV set.
Step 2. Press “EYE” button on the Adjustment remote controller.
Step 3. Block the Intelligent Sensor module on the front C/A
about 6 seconds.
When the “Sensor Data” is lower than 20, you can see the
“OK” message -> If it doesn’t show “OK” message, the Sensor
Module is defected one.
You have to replace that with a good one.
Step 4. After check the “OK” message come out, take out your
hand from the Sensor module.
-> Check “Sensor Data” value change from “0” to “300” or not.
If it doesn’t change the value, the sensor is also defected
one. You have to replace it.
5.4. LAN Inspection
1) LAN Port connection with PCB
2) Network setting at MENU Mode of TV
3) Setting automatic IP
4) Setting state confirmation
5) If automatic setting is finished, you confirm IP and MAC
Address
Green Eye-Check
Sensor Data : 492
BackLight : 100
OK
Содержание 42LM6700
Страница 77: ......