LG-Ericsson GDC-450H, Руководство пользователя

Страница: 24 / 66

GDC-450H Wireless Handset
User Guide
11
To subscribe to the system from the GDC-450H:
1. Press the
Menu
( ) button to display the menu.
2. From the menu use the
Navigation
( ) button to highlight Phone Register.
3. Press the
OK
( ) button; this displays the Phone Register menu.
4. Select “Subscription” using the up and down arrows of the
Navigation
( ) button
and press the
OK
( ) button.
5. Select an available BASE station number and press the
OK
( ) button; the
GDC-450H searches for the system, displaying and “Searching..x”. When a system is
found, its RFPI, is displayed. The RFPI of your system is available from your System
Administrator, or perhaps the attendant.
6. Press
OK
( ) button while highlighting the RFPI to continue the subscription to
the system, or
7. Press
No
( ) button to continue the search.
8. Enter your subscription Authentication code (AC); code is available from either your
System Administrator, or the attendant.
9. Press
OK
( ) button; on successful subscription, a confirmation tone is
received at the GDC-450H and the Attendant Station.
10. If the subscription fails, repeat procedure from Step 3 to 6 at the Attendant Station
and Step 1 to 8 from the GDC-450H (refer to Note).

Note:
Depending on the system or radio channel environment, the system or the wireless terminal
may not recognize that the system has the subscribed wireless terminal or the wireless
terminal is subscribed to the system. Once a user has performed the subscription procedure,
the user should attempt to make a call. Then, if a user can’t make a call, the subscription
procedure should be conducted again after selecting the unsubscribe menu item (refer to
Terminating a Subscription
section).
2.6.3 Terminating a Subscription
Unsubscribing will make a wireless terminal lose connection to the ipLDK-24/100/300/300E,
iPECS-50/100/300/300E/1200/MG WOTS. The subscription data of the phone (stored in
MPB and WTIB or the wireless terminal) should be erased separately at both User Station
and Attendant Station using the Unsubscribe procedure. To unsubscribe a wireless terminal,
it should be in an idle state.
To Unsubscribe from the Attendant Station:
TRANS/PGM
+ 0# + Flex. Button 2 + Station No. +
HOLD/SAVE
1) Press
[TRANS/PGM]
button. (
[TRANS/PGM]
LED flashes and
[MON]
LED lights
steady.)
2) Press
0#
.
3) Press Flexible button 2.
4) Enter the station number.
5) Press
[HOLD/SAVE]
button and confirmation tone is heard.
6) Confirmation tone (or error tone) will be heard at the Station, and the corresponding
Attendant Station.
7) LCD message
“
No Subscription
”
will be displayed if there is no subscribed system.
In rare cases when subscription data must be deleted from a lost phone, etc., the following
procedure may be used.