1.2
Safety instructions
For safety reasons, installers are responsible for familiarizing themselves with the contents
of this document and all warnings before performing installation.
1.2.1.
General safety precautions
Over-voltages or wrong wiring can damage the RESU10M(hereinafter “battery pack”)
and cause deflagration, which can be extremely dangerous.
All types of breakdown of the product may lead to a leakage of electrolyte or
flammable gas.
Avoid installing the battery pack where flammable materials are stored. Do not
install in places where explosive gas or chemicals are present.
During installation of the battery, the utility grid, solar input must be disconnected
from the Battery Pack wiring. Wiring must be carried out by a qualified personnel.
Battery Pack is not user serviceable. High voltage is present in the device.
The electronics inside the Battery Pack are vulnerable to electrostatic discharge.
Be sure to be grounded before handling the battery pack.
Read the label with Warning Symbols and Precautions, which is visibly under to the
Battery Cover (see Section 1.3)
1.2.2.
Battery handling guide
Store the product out of reach of children and animals.
Store the product where it should be minimal dust and dirt in the area.
Store at cool and dry place. (Do not store in greenhouses and storage areas for hay,
straw, chaff, animal feed, fertilizers, vegetables of fruit products.)
Store the product on a flat surface.
Do not store this product in a place exposed to direct sunlight.
Do not store the battery pack upside down on the ground.
If the battery pack is installed in the garage then ensure the product is above the
height of the vehicle bumper and/or door
Do not connect the power cable at terminal block opposite direction.
Do not put the battery pack upside down on the ground.
Do not expose battery to open flame.
Do not expose or place near water sources like downspouts or sprinklers.
Do not place the product nearby highly flammable materials. It may lead to fire
