4.6
Cable connections
4.6.1
Connecting network cable
It is required for the battery pack to communicate with the inverter for proper operation.
Connect a network cable between the battery pack and the inverter
1.
The small grommet is too small for an RJ45 plug to pass through. Without RJ45 plug
at the end, feed the network cable through a small grommet and then through the top
of the small cable entries.
2.
Attach an RJ45 plug to the network cable using a wire stripper and cable crimper.
Use this method to make a network cable, which is to be connected between the
battery pack and the inverter.
a. Cut network cable to the needed length.
b. Strip 2.5 to 5 cm of the outer sheath at one end of the cable.
c. Untwist and separate each pair of wires.
d. Arrange the wires in this order:
□ BPU Signal Connector PIN Map (RJ45)
□ Inverter Signal Connector PIN Map)
